Fiberglass Pipe Series 9500-A

Abrasion Resistant Pipe and Fittings for Severely Abrasive & Corrosive Industrial Service

Uses and Applications:

• Corrosive and Abrasive Slurries
• Waste Water and Sewage Systems
• Power Plant Bottom Ash Discharge
• Power Plant & Fly Ash Piping
• Plant Piping
• Water Treatment Piping
• Piping Systems for alkalies and Non-Oxidizing Acids

Description:

• Filament wound fiberglass reinforced vinyl ester epoxy composite pipe.
• ASTM D-2996 Classification Type 1, Grade 2, Class E.

Advantages:

• Working pressures from NBS-PS-15-69 Duct to 450 psi+, depending upon size and wall thickness.
• Vacuum to -14.7 psig for all sizes, by selection of wall thicknesses, ribs and filament wind angle.
• Available for earth burial, all depths, with selection of wall thickenesses, ribs and filament wind angle.
• Weighs 1/6 as much as steel. Thus, lower installation costs.
• The Resins used in Series 9100 Pipe meet the requirements of F.D.A. Regulations 21-CFR- 175.105 and 21CFR 177.2420.
• Smooth inner surface produces very low frictional loss for reduced pumping and fan blower costs. Hazen-Williams flow coefficient under 150.
• Recommended for a wide range of corrosion applications. Consult with Beetle Plastics or the resin manufacturer for specific project recommendations.

Composition:

• Nominal 110 mil glass veil and/or nexus reinforced corrosion liner, followed by a fiberglass filament wound structural overwrap.
• The liner thickness may be changed based on the application and service.
• The liner additive is a material with a hardness of 9 compared the diamond hardness of 10.
• Operating temperatures up to 300°ƒ.

Pipe Sizes:

Diameters, ranging from 1/2″ Ø up to 168″ Ø. Pipe available built to Iron Pipe Outside Diameters (ASTM D-2996,) as well as Pipe built to Chemical Process Piping Inside Diameter Standards.